11.
Since diodes are destroyed by excessive current, circuits must have:
A. higher voltage sources
B. current limiting resistors
C. more dopants
D. higher current sources
Answer & Explanation
Answer: Option B
Explanation:
No answer description available for this question. Let us discuss.
View Answer Workspace Report Discuss in Forum
12.
A diode for which you can change the reverse bias, and thus vary the capacitance is called a
A. varactor diode
B. tunnel diode
C. zener diode
D. switching diode
Answer & Explanation
Answer: Option A
Explanation:
No answer description available for this question. Let us discuss.
View Answer Workspace Report Discuss in Forum
13.
A filtered full-wave rectifier voltage has a smaller ripple than does a half-wave rectifier voltage for the same load resistance and capacitor values because:
A. there is a shorter time between peaks
B. there is a longer time between peaks
C. the larger the ripple, the better the filtering action
D. none of the above
Answer & Explanation
Answer: Option A
Explanation:
No answer description available for this question. Let us discuss.
View Answer Workspace Report Discuss in Forum
14.
Testing a good diode with an ohmmeter should indicate
A. high resistance when forward or reverse biased
B. low resistance when forward or reverse biased
C. high resistance when reverse biased and low resistance when forward biased
D. high resistance when forward biased and low resistance when reverse biased
Answer & Explanation
Answer: Option C
Explanation:
No answer description available for this question. Let us discuss.
View Answer Workspace Report Discuss in Forum
15.
The peak inverse voltage (PIV) across a nonconducting diode in a bridge rectifier equals approximately:
A. half the peak secondary voltage
B. twice the peak secondary voltage
C. the peak value of the secondary voltage
D. four times the peak value of the secondary voltage
Answer & Explanation
Answer: Option C
Explanation:
No answer description available for this