16. Which voltage source converts chemical energy to electrical energy? A. Electrical generator B. Battery C. Solar […]
16. How should a router that is being used in a Frame Relay network be configured to keep split horizon
11. Which of the following describes the creation of private networks across the Internet, enabling privacy and tunneling of non-TCP/IP
6. Which encapsulations can be configured on a serial interface? Ethernet Token Ring HDLC Frame Relay PPP A. 1
1. When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured? A. The
11. Which of the following describes the creation of private networks across the Internet, enabling privacy and tunneling of non-TCP/IP
6. Which encapsulations can be configured on a serial interface? Ethernet Token Ring HDLC Frame Relay PPP A. 1
1. When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured? A. The
11. Which of the following is true when describing a link-local address? A. Packets addressed to a unicast address
6. To enable RIPng, which of the following would you use? A. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0 B.
1. Which of the following is true when describing a multicast address? A. Packets addressed to a unicast address
1. What is the frequency range of the IEEE 802.11a standard? A. 2.4Gbps B. 5Gbps C. 2.4GHz
16. You are connecting your access point and it is set to root. What does Extended Service Set ID mean?
11. What is the maximum distance with maximum data rate for 802.11b? A. About 65-75 feet B. About
6. What is the maximum data rate for the 802.11g standard? A. 6Mbps B. 11Mbps C. 22Mbps
. What is the frequency range of the IEEE 802.11a standard? A. 2.4Gbps B. 5Gbps C. 2.4GHz
16. Which of the following is considered to be the destination host after translation? A. Inside local B.
11. Which command will allow you to see real-time translations on your router? A. show ip nat translations B.
6. Which of the following would be a good starting point for troubleshooting if your router is not translating? A.
1. Which command would you place on interface connected to the Internet? A. ip nat inside B. ip
1. Which command would you place on interface connected to the Internet? A. ip nat inside B. ip
16. Which of the following are valid ways to refer only to host 172.16.30.55 in an IP access list? 172.16.30.55
11. You configure the following access list: access-list 110 deny tcp 10.1.1.128 0.0.0.63 any eq smtp access-list 110 deny tcp
6. What command will permit SMTP mail to only host 1.1.1.1? A. access-list 10 permit smtp host 1.1.1.1 B.
1. Which of the following is true regarding access lists applied to an interface? A. You can place as
