11.
Which command displays the configuration register setting?
A. show ip route
B. show boot version
C. show version
D. show flash
Answer & Explanation
Answer: Option C
Explanation:
The show version command provides you with the current configuration register setting.
View Answer Workspace Report Discuss in Forum
12.
What should the configuration register value be after you successfully complete the password recovery procedure and return the router to normal operation?
A. 0x2100
B. 0x2101
C. 0x2102
D. 0x2142
Answer & Explanation
Answer: Option C
Explanation:
All Cisco routers have a default configuration register setting of 0x2102, which tells the router to load the IOS from flash memory and the configuration from NVRAM.
View Answer Workspace Report Discuss in Forum
13.
You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?
A. You must type the show ip rip command first.
B. IP addressing on the network is incorrect.
C. You must use the terminal monitor command.
D. Debug output is sent only to the console.
Answer & Explanation
Answer: Option C
Explanation:
To see console messages through your Telnet session, you must enter the terminal monitor command.
View Answer Workspace Report Discuss in Forum
14.
What does the command o/r 0x2142 provide?
A. It is used to restart the router.
B. It is used to bypass the configuration in NVRAM.
C. It is used to enter ROM Monitor mode.
D. It is used to view the lost password.
Answer & Explanation
Answer: Option B
Explanation:
The default configuration setting is 0x2102, which tells the router to load the IOS from flash and the configuration from NVRAM. 0x2142 tells the router to bypass the configuration in NVRAM so that you can perform password recovery.
View Answer Workspace Report Discuss in Forum
15.
You save the configuration on a router with the copy running-config startup-config command and reboot the router. The router, however, comes up with a blank configuration. What can the problem be?
A. You didn’t boot the router with the correct command.
B. NVRAM is corrupted.
C. The configuration register setting is incorrect.
D. The newly upgraded IOS is not compatible with the hardware of the router.
Answer & Explanation
Answer: Option C
Explanation:
If you save a configuration and reload the router and it comes up either in setup mode or as a blank configuration, chances are you have the configuration register setting incorrect.