6.
The signal voltage gain of an amplifier, Av, is defined as:
A. mca17_1003a1.gif
B. Av = IC × RC
C. mca17_1003c1.gif
D. mca17_1003d1.gif
Answer: Option C
Explanation:
No answer description available for this question. Let us discuss.
View Answer Discuss in Forum Workspace Report
7.
In a class B push-pull amplifier, the transistors are biased slightly above cutoff to avoid
A. crossover distortion
B. unusually high efficiency
C. negative feedback
D. a low input impedance
Answer: Option A
Explanation:
No answer description available for this question. Let us discuss.
View Answer Discuss in Forum Workspace Report
8.
The depletion-mode MOSFET
A. can operate with only positive gate voltages
B. can operate with only negative gate voltages
C. cannot operate in the ohmic region
D. can operate with positive as well as negative gate voltages
Answer: Option D
Explanation:
No answer description available for this question. Let us discuss.
View Answer Discuss in Forum Workspace Report
9.
Three different points are shown on a dc load line. The upper point represents the
A. minimum current gain
B. quiescent point
C. saturation point
D. cutoff point
Answer: Option C
Explanation:
No answer description available for this question. Let us discuss.
View Answer Discuss in Forum Workspace Report
10.
Which of the following conditions are needed to properly bias an npn transistor amplifier?
A. Forward bias the base/emitter junction and reverse bias the base/collector junction.
B. Forward bias the collector/base junction and reverse bias the emitter/base junction.
C. Apply a positive voltage on the n-type material and a negative voltage on the p-type material.
D. Apply a large voltage on the base.
Answer: Option A
Explanation:
No answer description available for this question.