16. You are connecting your access point and it is set to root. What does Extended Service Set ID mean? […]
11. What is the maximum distance with maximum data rate for 802.11b? A. About 65-75 feet B. About
6. What is the maximum data rate for the 802.11g standard? A. 6Mbps B. 11Mbps C. 22Mbps
. What is the frequency range of the IEEE 802.11a standard? A. 2.4Gbps B. 5Gbps C. 2.4GHz
16. Which of the following is considered to be the destination host after translation? A. Inside local B.
11. Which command will allow you to see real-time translations on your router? A. show ip nat translations B.
6. Which of the following would be a good starting point for troubleshooting if your router is not translating? A.
1. Which command would you place on interface connected to the Internet? A. ip nat inside B. ip
1. Which command would you place on interface connected to the Internet? A. ip nat inside B. ip
16. Which of the following are valid ways to refer only to host 172.16.30.55 in an IP access list? 172.16.30.55
11. You configure the following access list: access-list 110 deny tcp 10.1.1.128 0.0.0.63 any eq smtp access-list 110 deny tcp
6. What command will permit SMTP mail to only host 1.1.1.1? A. access-list 10 permit smtp host 1.1.1.1 B.
1. Which of the following is true regarding access lists applied to an interface? A. You can place as
16. You connect a host to a switch port, but the new host cannot log into the server that is
11. Which of the following provide inter-switch VLAN communication? ISL VTP 802.1Q 802.3Z A. 2 only B. 1
11. Which of the following provide inter-switch VLAN communication? ISL VTP 802.1Q 802.3Z A. 2 only B. 1 and 3
6. When a new trunk link is configured on an IOS-based switch, which VLANs are allowed over the link? A.
16. What are the distinct functions of layer 2 switching that increase available bandwidth on the network? Address learning Routing
11. Which of the following is a layer 2 protocol used to maintain a loop-free network? A. VTP B.
6. Which of the following statement is true? A. A switch creates a single collision domain and a single
1. What is the purpose of Spanning Tree Protocol in a switched LAN? A. To provide a mechanism for
16. Which of the following network types have a designated router and a backup designated router assigned? Broadcast Point-to-point NBMA
11. What are reasons for creating OSPF in a hierarchical design? To decrease routing overhead To speed up convergence To
6. Where are EIGRP successor routes stored? A. In the routing table only B. In the neighbor table
1. With which network type will OSPF establish router adjacencies but not perform the DR/BDR election process? A. Point-to-point
